- 精华
- 3
- 帖子
- 1099
- 威望
- 9 点
- 积分
- 1351 点
- 种子
- 5 点
- 注册时间
- 2005-5-9
- 最后登录
- 2020-4-9
|
发表于 2012-10-30 21:47 · 澳大利亚
|
显示全部楼层
具体看置顶教程
怎样在Rogero 4.21/4.30自制系统时正确更换PS3的硬盘
- Download the Downgrader PUP ---> Downgrader PUP mirror ---> Downgrader PUP
Size 176MB (184,595,263 bytes) MD5: 49d80e07fc1f5ca1b0840e02e94635db
- Rename the downloaded file to "PS3UPDAT.PUP" and put it on your USB in: "USB\PS3\UPDATE\PS3UPDAT.PUP"
- Swap the current HDD with the New HDD, Turn the PS3 on, follow screen instructions and let it install the Downgrader CFW.
- After the Downgrader CFW installs you'll be on a hybrid CFW3.55 that will still shows ver4.21 from system settings.
- Enable QA flag by following these steps:
1- Download the Rebug QA_Toggle package from here ---> toggle_qa.pkg
2- Put the "toggle_qa.pkg" on USB and Install it on the PS3.
3- Run the "Rebug Toggle QA" from XMB, the screen will go Black and you will see HDD Led activity then if all went fine you will hear 2 or 3 Beeps and the PS3 will Restart back to XMB.
4- If you want to make sure QA flag was set, go to "Network Settings" then apply the following key combo (all at the same time):
L1 + L2 + L3 (press left stick) + R1 + R2 + dpad_down
You should see Edy Viewer, Debug Settings, and Install Package Files if done correctly.
- Now put "Rogero CEX-3.55 CFW V3.7" on your USB in: "USB\PS3\UPDATE\PS3UPDAT.PUP" ---> Rogero CEX-3.55 CFW V3.7.PUP
- Start the PS3 into Recovery Menu and install "Rogero CEX-3.55 CFW V3.7" (from Recovery Menu, this is important)
- Once you're back on Rogero CFW3.55 v3.7 Start the PS3 into Recovery Menu and install any CFW 3.55/4.21/4.30.
中文翻译：
基本和软降自制回去3.55是一个步骤和方法，区别是换硬盘这步，以下是流程，具体请参考上面有关软降自制回到3.55部分的教程：
4.25to3.55 Downgrader 放到U盘
换硬盘
开机提示操作，擦U盘刷上这个Downgrader
装QA Toggle
开启并验证QA
恢复模式Rogero CEX-3.55 CFW V3.7
恢复模式刷要刷的自制系统 |
|
川公网安备 51019002005286号
楼主
