Status: Offline Trinity not glitching

Xbox3601974

Hello, Since I have got my DGX I have done over 15 slims. But this Trinity does not want to glitch. the green light on the dgx blinks normally, but it never boots xell. I have tried changing outpost cable to 10cm, 20cm, 50cm, 70cm, 90cm, 120cm and even 150cm. It never boots. I have also replaced all wires just in case.

I also tried with a 10pf and 27pf capacitor between cpurst and ground, and also using shielded wire for cpu rst at 8cm and 15cm.

Nothing seems to help, the green light just keeps blinking and after about 2 minutes the fan starts to tick fast. I do a hard reset and the same thing over again. Its been about hours and I cant get it to boot. Either the fans tick fast or the green light in the middle keeps blinking.

(the original nand still boots if i disconnect 5v from dgx)

What else could I try? is there a alternate trinity file?
Any help would be nice

I use flux, all the points look good, I re did all my wiring also.

Here are some photos, I did lift cpu rst point but I rebuilt it and it is working with original nand.

Xbox3601974

10cm cpu_rst
55cm post_out