SOS！SOS! SOS求救双65 512厚机遇妖机！！！！

该用户已被禁言

早上好 大侠们！！
     小弟双65 厚机 512 16202 版本的 求教几个问题   


我用NANDPRO提取两次nand显示正常刷机CB 6754 合成的时候提示出错  就用 用 -w64 写入 通用ECC  显示C:\nandpro20b>nandpro usb: -w64 1.ecc
NandPro v2.0b by Tiros

Looking for usb interface device
FlashConfig:00AA3020
512MB Nand Detected
Starting Block:0x000000
Ending   Block:0x000FFF
Configured for Large Block Nand
Writing
File: 1.ecc FileLen:21000 Blocks:8
0007

然后用JR写入的时候显示：
inished Checking Files
Version: 01
Flash Config: 0x00AA3020
Writing Nand
JASPER.ecc
Failed to write 0x0 block
Failed to write 0x1 block
Failed to write 0x2 block
Failed to write 0x3 block
Failed to write 0x4 block
Failed to write 0x5 block
Failed to write 0x6 block
Failed to write 0x7 block
Failed to write 0x8 block
Failed to write 0x9 block
Failed to write 0xA block
Failed to write 0xB block
Failed to write 0xC block
Failed to write 0xD block
Failed to write 0xE block
Failed to write 0xF block
Failed to write 0x10 block
Failed to write 0x11 block
Failed to write 0x12 block


然后用JR读取的时候 CB 变成9188  。。。。。。。。


接着我用RGH2.0焊接方法 A点55cm   脉冲篮板灯不亮  主机 狂闪绿灯？？？？？？ 我的机器显示的NAND信息是16202 的  篮板固件是14719 的  不亮灯 是不是跟脉冲板程序有关？？

该用户已被禁言

还有补充上面 ：我试过吧NANDPRO提取的原始固件BIN 用JR的 write NAND 写入也是显示Failed to write 0x0 block
Failed to write 0x1 block
Failed to write 0x2 block
Failed to write 0x3 block
Failed to write 0x4 block
Failed to write 0x5 block
Failed to write 0x6 block
Failed to write 0x7 block
Failed to write 0x8 block
Failed to write 0x9 block
Failed to write 0xA block
Failed to write 0xB block
Failed to write 0xC block
Failed to write 0xD block
Failed to write 0xE block
Failed to write 0xF block
Failed to write 0x10 block
Failed to write 0x11 block
Failed to write 0x12 block
......................................... 循环
不过最后显示DONE

用JR读取的时候变成CB6754 两次比较有没问题，但是 开机显示0022 就是三红。。。。。。。。。。。。。。这一下子 吧我搞的蛋疼菊紧。。。。。

孤い刃

内容帮顶，话说一串failed说明你刷ecc和nand什么的压根就没成功刷进去啊