[新闻] Maximus 360 FW Toolbox v4.5 发出

mr.h

Maximus 360 FW Toolbox v4.5 推出, 主要加强了为三星和日立伪装为BENQ的功能. 但还是不能***BENQ固件.


- Better BenQ Support
>> Maximus released 360 Firmware Toolbox(info) v4.5 - a graphical tool to handle several common dvd-drive firmware tasks.
From Readme/NFO:

MAIN NOTE:
THIS TOOL DOES NOT MAKE YOUR VAD6038 DRIVES RUN BACKUPS ON ANY WAY, THERE IS NO RELEASED IXTREME NOR XTREME FIRMWARES FOR VAD6038.
THIS TOOL NEITHER ALLOW DIRECT READING/FLASHING OF THE VAD6038 FIRMWARE YOU STILL NEED DUMP THE FIRMWARE WITH DOSFLASH Tools or with external programmer.

WHATS NEW ON V4.50:
- FIXED: Properly support Handling of VAD6038 Firmwares (see notes).
- FIXED: Previously Hitachi spoofed drives were not visible on toolbox anymore now you can see it and unspoof it or re-spoof them
- FIXED: Several other bugs

Release Notes:
The VAD6038 firmwares are tricky, the KEY could be placed on too many places, and the code locations could vary a lot between same ROM drives. (Like on Hitachi 78/79 drives but on VAD6038 there are a lot o of posibilities)
This Toolbox support the 2 retail VAD6038 firmware versions known till now. (62430C and 64930C). You can now:
- Read / Extract Keys
- Spoof Samsung/Hitachi drive as Benq
- Spoof Benq drive as Hitachi/Samsung

下载:

http://www.51ok.com/down.do?1C9C5103AF24E0BA22CDEC516ED07B9A7569764C6AB08B11.

该用户已被禁言

太好了，我等香港65的核心版本铺货了，入手一台，到时候还麻烦版主教我怎么换3星光驱。

mr.h

我个人并不爱用 Toolbox 啊...