X360KEY求助 开机E64

manmanjj

RT，那个KEY板子的小TF卡坏了，换了卡就E64
百度了一圈 说是小卡也有固件的，我下载到了固件，就是不知道怎么刷，求教这个怎么刷
我也用探针提取了光驱的dummy.bin，拷上去也是E64

manmanjj

agemoon

应该是拆机，把卡拿出来从新复制

agemoon

. Extract the three files "rootfs", "uImage" & "xkey.cfg"

2. Open xkey.cfg with Notepad and configure it if needed.
2.1 Add the three files to the root folder of a Flash Drive or HDD. (Make sure to "eject" the drive properly from the PC, it may otherwise cause corrupt files)

3. Connect the Flash drive or HDD to your xk3y remote and wait for the xk3y to start the update.
3.1 The remote OLED will now display "UPDATING - PLEASE WAIT" for about 35 seconds. (Do not turn off your XB360 or disconnect the remote while updating)

4. Once the update is completed, the OLED will display "UPDATE COMPLETE - RESET XBOX" Reboot your xbox and the xk3y should now be updated to the latest firmware.

5. That's it! Continue to enjoy using xk3y with the new features!

NOTE! If you use the same drive as you store games on to do the update with, then its recommended (not needed) to remove the "rootfs", "uImage" & "xkey.cfg" from the root of your drive after a firmware update. Since keeping them there will cause the xk3y to check the files if they are a newer firmware version then stored on your xk3y micro SD card, and because of that take longer time for your HDD to be recognized.

manmanjj

agemoon 发表于 2019-2-16 22:26
. Extract the three files "rootfs", "uImage" & "xkey.cfg"

2. Open xkey.cfg with Notepad and configu ...

噢，谢谢朋友，我的设备缺那个遥控器盒子，麻烦了

月夜猫

不用盒子也可以，直接用镜像恢复至TF卡，拷贝相应文件到卡上，设定配置文件即可。