[求助]我刷BENQ固件时，为何原版或Hack版的Key Location不同？

noom

H大的是这样的：


我的是：
Original Firmware Version: BenQ VAD6038 64930C
      Key Location: 0xA040

  Hacked Firmware Version: BenQ VAD6038 64930C
      Key Location: 0xE040  Hacked FW Type: iXtreme v1.51-12x-FINAL

*** SUCCESS ***
Drive key copied.
Drive serial copied.

Your hacked firmware is now ready to be flashed!

我的原版Key Location是 0xA040，Hack版是Key Location: 0xE040。
而H大的Key Location都是在0xE040的。

为什么会这样？？.

noom

UP UP UP，这样有影响吗？

noom

自问自答：

BenQ has 5 potential key ranges: 0xA000-0xAFFF, 0xB000-0xBFFF, 0xC000-0xCFFF, 0xD000-0xDFFF, and 0xE000-0xEFFF. So, your firmware will have one of those ranges as your key section. You can easily spot the section, as the key will usually be in the first 40 bytes of the range, and the rest of the range will be bytes of 'FF' until the end of the section.

This tutorial will give you an idea of what to look for in your firmware.

Caster.


There are 5 'key' revisions of the firmware. The 5 possible key ranges start at: A000,B000,C000,D000,E000. So, yours is type 1, which starts at A000. The iXtreme firmware is type 5, which starts at E000. A benq key that is 'injected' into iXtreme firmware will always be in the E000 range, and if 'injected' with firmtool, at the same offset in the E000 range as whatever offset it was at in your original firmware (so, A030 vs E030). If both keys are the same, it should funtion fine.

So, you get the 'Insert disc into Xbox360 console' error?

Unregistered007 is talking about the 'Make iXtreme firmware' command i believe, which uses firmtool.

Caster.

mr.h

KEY多位置在LG78就开始了.

noom

下面是引用mr.h于2009-03-08 14:50发表的:
KEY多位置在LG78就开始了.

其实这样会唔会说影响固件的伪装性？让MS看出我位置不对BAN机？

mr.h

不会影响.              .