No pin lifting or epoxy removing needed anymore! Just solder anything on the back according to this picture.
Also if you got status 0x52 instead of 0x72 with the "1,8V-method" this should do it. I already dumped 4 drives with this method without any issues.
-switch in pos 1
-power drive
-start Dosflash --> SPI should get recognized with status 0x72
-put switch in pos 2
-click "read"
unsolder anything and reconnect the lines that have been cut..
川公网安备 51019002005286号
楼主
发表于 2009-12-1 22:30 · 辽宁
