- 精华
- 0
- 帖子
- 253
- 威望
- 0 点
- 积分
- 397 点
- 种子
- 32 点
- 注册时间
- 2006-9-14
- 最后登录
- 2024-10-21
|
本帖最后由 rinnng8 于 2011-7-15 14:49 编辑
http://consolecrunch.com/downgrade-to-any-firmware-by-seal-team-6
2009年2月之前的ps3可降级为3.21~
Thetechgame.com have found a way to downgrade PS3′s (made before the 17th February 2009) to OFW 3.21, meaning of course where you go from there is entirely up to you (REBUG anybody?)
Thetechgame.com这个网站最近发现了一种方法可以降级2009年2月17日之前出厂的机器到3.21的系统。。。
_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-ST6'z Downgrade + JailbreaK!!!!!!_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-
Please note: We are not responsible for any problems you have, or malfunctions your hardware may recieve. You know that this tutorial could cause your system to YLOD, Wipe all memory, and brick, at your mistakes.
By reading on, you agree to the statement above, and do notice I am not liable.
You have been warned.
注意。一些免责的声明。。。
Getting started:
*2 USB Flashdrives, 4 GB or more* <<<<< That means NO (Reapeat) NO 2GB Flashdrives!
2个u盘(4g以上)
*2 PS3 Controllers Via USB*
2个ps3无线手柄 和usb线
*A Computer, you obviously have one -.-*
一台电脑。
*A disk that will run in your PS3, BUT NO DvD's!, CD's Work best, or EARLY PS3 Games (EARLY!!!) *
一个cd或者一个正版的老游戏。
Format BOTH USB's Before starting below!
开始工作前要格式化你的u盘
***Take your game out of your disk drive***
先要确定你机器里没有任***盘。。。游戏盘
First on one of your flashdrives, You will need OFW 3.21, Found here: downloads.exophase.com/634/ps3-firmware-321/
首先 你需要下载好官方的3.21的固件包。下载地址如上
Your second USB will contain your desired frimware,
Whether that friware is 3.55, or 3.56, 3.66,
Just put it on the USB in the PS3 UPDATE folder
-Now go to your PS3, start the restore mode menu.
----**Okay, all idiots that don't follow from here on WILL brick their console, seriously.**------------
----*Plug in both controllers, if your second controller does not turn on, you are okay,
if it does, you need to put it back into restore.---------
-----Click "Restore System Default" With first controller, and AS YOU press it, unplug your power cord,----
While spamming the O Button on 2nd controller. <<< Note: My brother always helped. :l
Okay so as soon as you unplug your PS3, make sure Controller 2 is still spamming O
Plug power cord back in, Hold the "Disk Eject" Button for 15 seconds.
Still spamming O
After 15 seconds, quit spamming O, Unplug controller 1, Put controller 2 into Controller 1's slot
Put USB with 3.21 in.
Enter restore mode.
If you did it correctly, you should go to Update, and be able to update to 3.21, if not retry,
My first console took 4 trys. Don't worry.
After you update to 3.21, Unplug power cord. Put the 3.21 USB in Controller 2's slot, put Desired Frimware USB in other slot, use wireless controller now.
Instert your CD/ early Game.
Turn on your console.
Keep pressing the PS button on your controller in tell it brings up a screen that looks like recovery screen.
there will be 3 options
"Terminate HDD Memory"
"Report Sytem Defect to Main Hub"
"Insert new Default Update"
And you will see the Registerd TradeMark Sony PS3 at the bottom.
Turn off your controller, unplug 3.21 USB, plug in Controller 2.
Press "Insert new Default Update"
It will ask for default update's registration code.
Here are a list of registration codes, they all work.
DO NOT Input them wrong, or it will YLOD your sytem.
3.55- 49-9034-3554
(Note: There are different codes for slims, which you can PM me to recieve)
3.56- 50-2534-3565
3.60- 71-6774-3607
3.61- 72-2378-3617
3.66- 94-3298-3669
Then it will say "Override error" Have an option to click "OK" or press O to leave the screen.
Switch controllers from controller 2, to controller 1, then press "OK"
It will ask for the serial number of the system.
Just enter "PS3XPR.%34" For fats and "PS3XPR.%34S" for slims.
And it will let you continue.
It will ask you to click "OK" one last time
Then you will have to press "Install"
Let it download the update, When it's finished, it will shut down, the red light will flash 3 times, Green 3 times, Red 4 times, Green 3 times, Red 5 times, Green 3 times,Red 6 times, green 4 times.
IMMIDEIETLY at the end of Green 4 times "Beep, Beep, Beep, Beep"
You have to unplug the power cord.
Then plug it back in after 15 seconds.
You will start up your system with none of your USB slots being used, it will then install the update, and restart your console.
Congratulations, your ready to jailbreak!
Edit:
Recently discovered;
Any PS3 made after February 17th, 2009,
Cannot downgrade this way.
The reason is in 2009 Sony changed all registration keys for PS3's.
Okey, I see alot of people making new threads asking if their PS3 was made before the 17th of February 2009. Some of you aren't even looking at the right thing. In the middle of the PS3 there is a code. A number and a letter, like this: 9C. If your PS3 is made before 9A then you are good to go. I'm going to make a list if some of you still don't get it.
6 - 2006
7 - 2007
8 - 2008
9 - 2009
0 - 2010
A - First quarter of the year
B - Second quarter of the year
C - Third quarter of the year
D - Fourth quarter of the year
First quarter - January, February, March
Second quarter - April, May, June
Third quarter - July, August, September
Fourth quarter - October, November, December
For example, 9C means that is was made in in the third quarter of 2009, either July, August or September, and that this method of downgrading does not work on that system. As I said earlier it only works on system made before February 17th 2009, so that means that it doesn't matter if your system was made 9A, it has to be before that.
|
|