- 精华
- 0
- 帖子
- 966
- 威望
- 0 点
- 积分
- 1400 点
- 种子
- 2 点
- 注册时间
- 2011-5-19
- 最后登录
- 2019-12-12
|
本帖最后由 xxxpp24com 于 2011-10-2 02:12 编辑
MD山内你有种...
拿了T500在GT5试漂....根本甩不起来!!!!!雨宫的RX7跟猴子的34都是,甩都甩不起....真不知道T500那强劲的回盘速度是干什么用的....
所以想买T500的,如果想漂移,还是放弃GT5吧.....山内你太有种了...
========
* PROCEDURE TO PERFECTLY CENTER THE WHEEL
1) Once the wheel is connected (and after the wheel has calibrated
itself), turn the wheel completely to the left and then completely to
the right.
2) Next, move the wheel to its perfectly centered position.
3) Simultaneously press and then release the “START + SELECT + MODE” buttons.
4) The wheel’s new central value is automatically and permanently saved in the wheel’s internal Flash memory
(note: do not repeat this procedure each time you reconnect the wheel).
IMPORTANT: Be sure not to not use this procedure too often, since there
are a limited number of times that changes can be written to the wheel’s
internal Flash memory.
= This procedure must be used only to modify the factory setting of the wheel’s central value.
==============
如果我超出了闪存的记忆空间会怎样?无法再记忆?
如果我超出了该怎么办?怎么看超是否超出?可否删了闪存里的数据?
我曾经7次这样3个键长按6秒左右或以上,这样怎么算?到底要按多久?
现在只是自检时没在正中心而已,但在驱动跟在游戏里准心是没问题的 |
|