- 精华
- 0
- 帖子
- 1152
- 威望
- 0 点
- 积分
- 1119 点
- 种子
- 0 点
- 注册时间
- 2010-1-3
- 最后登录
- 2014-11-23
|
有同學求翻, 我隨便翻個
==========================
For this custom firmware you will need two hard drives and a e3 flasher or similar device to downgrade your PS3
對於這個自制固件, 你需要2個外置硬盤及一個E3 Flasher 或者類似的東東去降級你的PS3
(assuming that your on firmware 4.00 and you have an e3 flasher)
(假設你的PS3是官4.00和有E3 flasher)
•downgrade to 3.55 using the downgrade tools from e3
用E3 降級到3.55
•once booted back into the xmb turn off the console
當你開機進入XMB時關掉主機
•swap hard drives turn on the system, press the PS button and you will be asked to reinstall the firmware
換第二個硬盤再開機, 按下PS按鈕, 然後你會被要求重新安裝固件
•place the pup file from the e3 downgrade tools in the normal PS3/UPDATE usb folder and follow the on-screen instructions to reinstall the firmware
把從E3取來的pup文件放到PS3/UPDATE USB 文件夾, 然後按照畫面上的指示完成固件的重新安裝
•then install dev_blind.pkg & Blackb0x FTP from install packages
然後安裝 dev_blind.pkg & Blackb0x FTP
•run dev_blind then BlackB0x and FTP into the console
運行dev_blind 然後開啟BlackB0x, 再用FTP連入PS3
•goto /dev_blind delete everything and replace them with the files included in the download when finished copying
進入/dev_blind, 並刪掉所有的東東, 再將下載的文件覆蓋上去
•press the ps button and the console should reboot and and ask to reinstall the firmware again, switch off the console and swap the hard drive back
按下PS按鈕, 主機會重啟並再次要求重裝固件, 關掉PS3再換回第一個硬盤
•turn on the console press the ps button twice
開機, 按下PS按鈕兩次
•the console should boot back into 3.55 Rogero
主機應該會進入3.55 Rogero
•goto system update and install 4.00 OFW
去系統更新, 並安裝4.00 OFW
•once installed turn the console off again and swap hard drives back and you should boot into a modified 4.00 kiosk firmware.
完成安裝後, 關掉主機, 再次換回第二個硬盤; 這時, 你應該就會進入修改版的4.00 kiosk 固件
NOTE: This only allows installation of retail signed packages and is not modified to run unsigned code..
注意: 只支持安裝己簽名的PKG, 並不允許運行未必簽名的程序碼
To Unlock the XMB: Hold L1+R1+Select+Square simultaneously. When the security settings icon is selected. It will ask for you to input a code (four digit code). Enter 0000 if that doesn't work try 0219.
解鎖XMB : 同時按住L1+R1+Select+Square. 當選擇了安全設定的圖標後. 你會被要求輸入4位的密碼. 密碼是0000, 如果不行就試0219
|
|
川公网安备 51019002005286号
楼主
发表于 2011-12-22 19:43 · 吉尔吉斯斯坦
