Signal from Card to PSX. This signal is an 8 bit serial transmission synchronous to the falling edge of clock (That is both the incoming and outgoing signals change on a high to low transition of clock. All the reading of signals is done on the leading edge to allow settling time.)
COMMAND
Signal from PSX to Card. This signal is the counter part of DATA. It is again an 8 bit serial transmission on the falling edge of clock.
VCC
VCC (heared to be) 3.6V. The main board in the PSX also has a surface mount 750mA fuse that will blow if you try to draw to much current through the plug (750mA is for both left, right and memory cards).
ATT
ATT is used to get the attention of the card. This signal will go low for the duration of a transmission.
CLOCK
Signal from PSX to card. Used to keep units in sync. 250KHz clock for PlayStation
ACK
Acknowledge signal from Card to PSX. This signal should go low for at least one clock period after each 8 bits are sent and ATT is still held low. If the ACK signal does not go low within about 60 us the PSX will then start interogating other devices.
川公网安备 51019002005286号
楼主
发表于 2012-6-24 23:31 · 吉尔吉斯斯坦
