- 精华
- 0
- 帖子
- 70
- 威望
- 0 点
- 积分
- 72 点
- 种子
- 2 点
- 注册时间
- 2010-12-3
- 最后登录
- 2019-12-6
|
发表于 2013-3-17 04:05 · 英国
|
显示全部楼层
Step 6:
Remove the Glitch chip and the rest wires if you want to
On JR load the nanddump.bin file on source and hit Write Nand, that will revert your console to stock
After that's done, you're finished with RGH part, remove nand wires if you want to and set R/W adapter to X360 if you used one
Step 7:
Click Tools -> Extract Files
Well, do i really need to say anything about it
Just check there are no errors on the log
Step 8 & 9:
Optional: Connect your Stock drive to your pc
on JF load on target the LTU fw that matches your drive version
Right click on the grey area and hit Key C/R
A pop up box will appear, load the files you extracted from JR in there
Press ok and JF will create you ltu cfw, it will also grab any unique info from your drive, this isnt needed so if you dont have the drive its ok, but its always nice to have unique info right?
Once done save the cfw
Step 10:
You will need to put the replacement pcb on a SLIM LITE-ON chassis, you can either remove your stock pcb from the drive, or use a spare one
Connect it to your pc, power it on, and load the 0800 DL, you can download that inside JF
0800 How to
Code:
Burnt to Dual Layer + R Media (this is vital for later firmwares).
Simply burn it with no layerbreak settings, with all data present on first Layer.
IMGBurn will do this fine just select the ISO and
confirm you want to burn to a large capacity disc with all data present on L0 (Layer 0).
Let it finish reading it, i.e. spinning off and hit Intro/Device ID
With your cfw loaded in target, hit Write
Note that it wont verify, so once finishes writing Bank 3, you can then Outro
and thats it.
Step 11:
Donate to the teams and go play your back-up'd games |
|
楼主: linun
川公网安备 51019002005286号
楼主
