【转载】通过一台PC就可以玩wii盗版的软件,不需要***

zeroday

利用一根自制的线连接wii和pc,用pc来完成IC的功能
WabModcheap: use your PC as a modchip - D2B support !

WAB just released the sourcecode for the WabModcheap - an application which lets you run your backups without installing a modchip. You can connect your Wii to your PC (using a selfmade cable) and then use the application to simulate a modchip.
Get it at the download page

Update: The archive now also contains a compiled .exe. No need to compile it yourself anymore

下载地址

http://www.wii-xposed.com/downloads.php

连接线制作方法
感谢echo1978的翻译

需要db-25插座，和2个二级管，然后一些导线

1脚接一个二极管的负极（有黑色线标的）
14脚接一个二级管的负极
18脚接线
11脚接线

在ic3001附近找到焊盘符号
- 1 -
2 3 4
- 5 6


1脚的二极管正极接焊盘4
14脚的二级管正极接焊盘6
11脚接焊盘3
18脚接GND

p3001，最右边的焊盘是GND
从右数第三个焊盘也是GND

线做好后用万用表测量一下

运行./dvdtool -r 0x8000 在root mode
什么是root mode？
如果看到十六进制数
那么你就成功了
否则就要检查线，还有是否在root mode（还是不明白）
还有就是parport0 和ppdev驱动是否安装正确
（估计是在linux下运行的）

Making the datacable

      In order to make the datacable, you need only a few basic items. A DB-25 connector, two diodes, and some cable. Connect the diodes in reverse (so, PC ---|<--- Wii) to the DB-25 connector, to pins 1 and 14. Just connect some wires to pins 18 and 11, these will be the GND and output wires. The other two dioded wires are clock and input. Now, open your Wii, remove the DVD drive, and turn it over. Look for the following pattern near IC3001 (http://wiire.org/Wii/console/disc_drive):
      - 1 -
      2 3 4
      - 5 6

      3 is SBO1 (Output)
      4 is SBT1 (CLK)
      6 is SBI1 (Input)

      With the numbers being pads, and - being nothing. Now, solder the wire from pin 1 to pad 4 (CLK line). Pin 14 goes to pad 6, and pin 11 goes to pad 3. Just find a suitable place to attach the wire from pin 18, which is GND. (Placing the board so you can read the writing on IC3001, look at connector P3001, the rightmost pad is GND and the third from the right is GND). Check your solder connections with a multimeter, then close up your Wii, and issue the ./dvdtool -r 0x8000 command in root mode. If you see hexadecimal numbers, congratulations! If you don&#39;t, check the proper functioning of your cable, wether or not you&#39;re in root mode, and if the parport0 and ppdev drivers are properly installed.

还要拆光驱啊







.

Stormxx

火星乐~

https://bbs.a9vg.com/viewthread.p ... page=1&toread=1