How To Replace A Slim Power & Eject Switch Ribbon Flex Cable

Xbox3601974

Tools Used

Marker Pen
Pick and Hook Tool or Small Flat head screw driver
Twezers
Q-Tips
Reflow Wand or some way of Heatgunning to remove the old ribbon if not it will still come off but it's harder to remove it.



First Thing is To Disconnect The Face Plate Ribbon From The 360




Next Remove The Plastic Clip Holding The Ribbon
I see in videos that this is being broke off for no reason it will pop off if you take your time i used a Pick and Hook Tool here very easy to get the inside clip just pry it up slowly .




Or Just Use A Small Flat Head Screw Driver A Bit Tricky To Get The Inside One




Next Get A Marker Pen & Mark A Template



Next Use Heatgunning & A Twezers To Remove The Ribbon A Nice Low Heat Do Not Go Mad And Melt The Face Plate.





Now Fit The New Ribbon Peel Back A Bit At A Time & Use A Q-Tip To Stick And Smooth Out The Ribbon Like Shown Below






Now Snap The Plastic Clip That Was Holding The Ribbon Back On Small Bit Of Glue If Needed Job Done Put Your Slim Back Together


How To Replace A New Benq / Liteon Laser HOP-1401
How To Replace A Slim Power & Eject Switch Ribbon Flex Cable
How To Update Your JTAG To Newest Dash 2.0.15574 Using J-Runner GUI

gaohang4918

外国人？请个中国朋友先把你问题翻译一下~这···

guoguohohoho

全是问题，没看出名堂。关键是用什么换啦。

razor2012

三个问题分别是， 如何换benq光驱激光头   如何换前面板？   如何把jtag自制升级到15574