问问这是什么***

该用户已被禁言

Crystal Chip 2.0
Hardware Features

• Full Autoboot of all media, 100% no-swap direct boot
• Compatible with all console revisions v1 - v15b
• Compatible with all PAL/NTSC sytems, all regions supported
• HDD, USB, MC, Flash "Dev Mode" support
• DVD Region Free with RCE, Green Screen(RGB) Fix and DVD Color Fix
• Macrovision "OFF"
• Upgradable firmware
• Quick boot mode
• Hardware and software based boot modes such as "Sleep","Enhanced" and "Minimal"
• PBAT scripting for automating homebrew software and menus
• Installation control onboard LED
• High timing stability - Onboard Crystal Oscillator
• Hardware Recovery Mode
• Completely jumperless, auto-configuration
• 1 megabyte Dataflash with DFFS (DataFlashFileSystem)
• Multdisc-Games Support
• ACTEL FPGA Technology
• Custom glitch detection logic & noise filter
• Professional 4-Layer PCB design
• Easy installation, max. of only 21 wires
• High quality anti-static packaging incl. case sticker
• Quality & functionality control for each item

Firmware Upgrade Mode

* The "firmware" stored in the EEPROM on your CC PCB is used for hooking into the PlayStation 2 system software. Upgrading your CC firmware is as simple as downloading, burning, and booting a Crystal Chip Utility Disc. A simple menu allows you to update your firmware without hassles.


Recovery Mode

* The CC1.0/CC1.1 has a built-in Recovery Mode which may be enabled at any time to allow you to recover from corrupted firmware. Thanks to an internal checksum, CC will automatically detect corrupted firmware and boot in Recovery Mode. In the event that CC fails to automatically detect corrupted firmware, you may force "Recovery Mode" by pressing reset 3 times on startup.


Hardware Sleep Mode

* CC1.0/CC1.1 has a "Hardware Sleep Mode" (aka HSM) which allows you to disable your Crystal Chip. Unlike "Software Sleep Mode", HSM does not require any patching to be done in order to get software running which will disable the chip. This is quite useful if you get no video on startup and suspect that your CC may not be working correctly. You may use HSM to disable the chip and see if your PS2 then starts up. If not, it's very likely that the cause is your wiring/etc rather than the chip.

Hardware Sleep Mode may be entered by pressing reset 6 times on startup. Your CC will remain in sleep mode until you power off the console or put it into standby mode, to prevent you from accidentally enabling the chip
.

55272017

好像是7W的IC............

alexwong

這個也是免光盤引導的直讀，性能和原版MI差不多，直讀界排名第三。