- 精华
- 0
- 帖子
- 6793
- 威望
- 0 点
- 积分
- 6937 点
- 种子
- 593 点
- 注册时间
- 2012-5-29
- 最后登录
- 2024-12-28
|
楼主 |
发表于 2019-8-17 17:38 · 广西
|
显示全部楼层
不知道为甚会吞楼,就把上面没翻译完的一段段发吧。。
- With regards to the VGA output in the deskmini A300 box, I have to say I'm really surprised to find it's perfectly usable, even in the BIOS setup (with a 31 kHz monitor in this case, obviously). Being a DisplayPort on the inside means that the motherboard must have some chip for digital to analog conversion, that does a really good job. It was a nice surprise to realize that there's no low dotclock limitation for this output. This is not the case for the HDMI output, which is not usable for 15 kHz precisely for this, at least with the current patches in this driver (maybe some extra limits must be removed). But in my experience, even with the limits removed, HDMI has always had remaining limitations that virtually forced you to use super resolutions. Well, this is not the case with this "VGA" output, and it's good.
- 关于 deskmini A300 小主机 中的 VGA 输出,不得不说它的完美适用 非常另我吃惊,即便在 BIOS 设置中(显然,此时使用31kHz 显示器)。VGA内部为 DisplayPort 意味着主板有一些芯片进行 数模转换,且处理得非常好。。让人惊喜的是没有 低像素时钟限制 的输出。。HDMI 输出的情况并不同,无法准确适用在15kHz上,至少目前驱动程序中的补丁如此(或许一些额外的限制 必须删除掉才行)。但根据我的经验,即使删除了限制,HDMI 仍有其它限制 以至于你必须使用 超级分辨率 去解决。嗯,这个"VGA"输出没有这些情况,很好。
——"VGA"口,即伪VGA口(DP转的),居然没有低像素时钟限制,HDMI 接口倒是有此限制,HDMI接口是这块主板的特殊现象,还是2400G导致的? |
|